LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2004 >> Axiom Base, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Diagnostic Information & Procedures >> On Vehicle Service >> Throttle Position (TP) Sensor >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Disconnect the TPS electrical connector.
  3. Remove the bolts and the TP sensor from the throttle body.
Fig 1: Removing Bolts And TP Sensor From Throttle Body
G02788890Courtesy of ISUZU MOTOR CO.
NOTE: Do not clean the TP sensor by soaking it in solvent. The sensor will be damaged as a result.
scientia non olet · About LEMON Manuals