LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2004 >> Axiom Base, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Control System >> General Description >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control System: General Description: Notes

The AW30-40LS is a fully electronic controlled 4-speed automatic transmission. It uses a microcomputer as a control unit to judge running conditions including throttle opening rate and vehicle speed, then it sets the shifting point in the optimum timing so that best driving performance can be achieved.

In addition, the built-in shift mode select function can select two shift modes according to the driver's preference:

Also, the built-in fail-safe function ("backup mode") assures driving performance even if the vehicle speed sensor, throttle signal or any solenoid fails.

Further, the self-diagnostic function conducts diagnosis in a short time when the control system fails, thus improving serviceability.

The major features of AW30-40LS are as follows:

NOTE: When the TCM is repaired, DTC P1601 (ECM code) is stored at 2 times ignition "ON" at the state which disconnected a TCM connector. (Turn on the Check Engine Lamp).
Therefore, DTC P1601 (ECM code) is set at above condition when the TCM repaired. Clear the DTC after verify repair.