LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jaguar >> 1992 >> XJS 2D Convertible >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor (XJS) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Distributor (XJS): Removal

  1. Disconnect negative battery cable. Raise and support vehicle. Remove crankshaft sensor (flywheel sensor) heat shield. Remove flywheel sensor. Rotate flywheel until No. 1 piston is at TDC. Ensure crankshaft timing marks are aligned.
  2. Install flywheel sensor and heat shield. Lower vehicle. Disconnect front and rear coil connectors. Remove bolts from cruise control bellow support bracket. Disconnect wiring harness connector and vacuum hose from cruise control assembly.
  3. Lift cruise control assembly and position aside. Remove distributor cap. Ensure distributor rotor is aligned with TDC mark on distributor housing. See Figure . Remove distributor retaining bolts and distributor.
scientia non olet · About LEMON Manuals