Self-Diagnostic Tests: Notes
NOTE:
Some driveability problems may have been corrected by manufacturer with a revised Powertrain Control Module (PCM). Prior to replacing PCM in following tests, always check if any Technical Service Bulletins (TSBs) apply to vehicle being tested.
CAUTION:
Perform all resistance and voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm impedance, unless stated otherwise in test procedures. Ensure ignition switch is in OFF position when performing resistance tests, unless stated otherwise in test procedures.
NOTE:
Not all Diagnostic Trouble Codes (DTC) are applicable to all models. Ensure specified DTC test procedure applies to model being repaired.