LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jaguar >> 2000 >> XJR >> Repair and Diagnosis >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts >> Introduction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Controls - Sensor Operating Range Charts: Introduction

Sensor operating range information can help determine if a sensor is out of calibration. An out-of-calibration sensor may not set a trouble code, but it may cause driveability problems.

NOTE: Unless stated otherwise in test procedure, perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance.
CAMSHAFT POSITION SENSOR RESISTANCE (1)

Application Ohms
S-Type 200-400
XJ8, XJR, XK8 & XKR 1850-2500
(1) Measure between sensor connector terminals.
CRANKSHAFT POSITION SENSOR RESISTANCE (1)

Application Ohms
S-Type (2)
XJ8, XJR, XK8 & XKR 950-1250
(1) Measure between sensor connector terminals No. 1 and 2.
(2) Information is not available from manufacturer.
ENGINE OIL TEMPERATURE, ENGINE FUEL TEMPERATURE & INTAKE AIR TEMPERATURE SENSOR RESISTANCE (S-TYPE)

Temperature °F (°C) Ohms
248 (120) 1180
230 (110) 1550
212 (100) 2070
194 (90) 2800
176 (80) 3840
158 (70) 5370
140 (60) 7700
122 (50) 10,970
104 (40) 16,150
86 (30) 24,270
68 (20) 37,300
50 (10) 58,750
-40 (-40) 92,500
INTAKE AIR TEMPERATURE & ENGINE COOLANT TEMPERATURE SENSOR RESISTANCE (XJ8, XJR, XK8 & XKR)

Temperature °F (°C) Ohms
-4 (-20) 15,000
32 (0) 5740
68 (20) 2450
104 (40) 1150
140 (60) 584
176 (80) 320
212 (100) 184
HEATED OXYGEN SENSOR VOLTAGE

Condition Specification
Lean Less Than 400 Millivolts
Rich 600 Millivolts To One Volt
KNOCK SENSOR RESISTANCE

Application Ohms
S-Type 4500-5500
XJ8, XJR, XK8 & XKR (1)
(1) Information is not available from manufacturer.
TP SENSOR VOLTAGE

Application Voltage
All Models (1)
(1) Information is not available from manufacturer. See PIN VOLTAGE CHARTS article.
MAF SENSOR VOLTAGE

Application Voltage
S-Type (1)
XJ8, XJR, XK8 & XKR (2) .7-1.7
(1) Information is not available from manufacturer. See PIN VOLTAGE CHARTS article.
(2) Disconnect MAF sensor connector. Connect jumper wire between MAF connector terminal No. 1 MAF terminal No. 1. Connect another jumper wire between MAF connector terminal No. 5 and MAF terminal No. 5. Start engine and let it idle. Measure voltage between MAF terminals No. 1 and 5.