Anti-Lock Brake System (ABS) Module: Installation

Install the ABS/TCCM to the HCU.
- Install and tighten bolts. (1)
- Connect electrical connector. (2)
Fig 1: Installing ABS/TCCM To HCU
Courtesy of JAGUAR CARS, INC.
Install HCU.
- Taking care not to distort brake tubes position HCU into bracket.
- Install bolts and tighten to 8-10 Nm.
Fig 2: Installing HCU
Courtesy of JAGUAR CARS, INC.

NOTE: To minimize brake fluid loss, install the brake tubes to the HCU in the order shown.

Fig 3: Installing Brake Tubes To HCU

Courtesy of JAGUAR CARS, INC.

Install brake tubes to HCU.
- Remove plugs from outlet HCU ports and brake tubes. (1)
- Install and tighten outlet brake-tube union nuts. Refer to BRAKE TUBE, HOSES AND BRACKET TORQUES for torque setting. (2)
- Remove plugs from inlet HCU ports and brake tubes. (1)
- Install and tighten inlet brake-tube union nuts. Refer to BRAKE TUBE, HOSES AND BRACKET TORQUES for torque setting. (2)
Remove cloth from underneath HCU.
Connect electrical connectors to the ABS/TCCM.
- Connect electrical connector. (1)
- Connect electrical connector. (2)
- Push plunger downwards. (3)
Fig 4: Connecting Electrical Connectors To ABS/TCCM
Courtesy of JAGUAR CARS, INC.
Remove special tool from brake pedal.
Reconnect battery ground cable (IMPORTANT, see DISCONNECTING/CONNECTING THE BATTERY for further information).
Bleed brake system. Refer to BLEEDING BRAKE SYSTEM .