Brake Shift Interlock Actuator Adjustment
- Remove battery cover and disconnect ground cable from battery terminal. Refer to BATTERY DISCONNECTION PROCEDURE .
- Remove the J-gate surround. See SELECTOR LEVER GATE FINISH PANEL .
- Remove the console finisher veneer panel. See FLOOR CONSOLE FINISH PANEL .
- Remove the interlock solenoid actuating lever cover.
- Move the shift lever to N.
- Operate the gearshift interlock latch manually to release the selector lever from P .
- Adjust the gearshift interlock solenoid.
- Slacken the solenoid fixings.
- Hold the selector lever midway between P and R .
- Move the solenoid rearwards, against spring pressure, to take up the free play.
- Tighten the solenoid securing nuts.
- Ensure that the interlock actuating lever has no free play with the selector lever midway between P and R .
- Further installation is the reverse of the removal procedure.
- Perform the BATTERY RECONNECTION PROCEDURE .
NOTE:
Assistance from another person is required.