Output Shaft Speed (OSS) Sensor: Removal
- Remove the battery cover and disconnect battery ground cable.
- Raise the vehicle for access.
- Carefully remove the drain plug and drain the transmission fluid. See Figure.
WARNING: TRANSMISSION FLUID MAY CAUSE SEVERE BURNS, ENSURE THAT ALL SAFETY PROCEDURES ARE OBSERVED. - Remove the twenty-two fixings which secure the fluid pan.
- Remove the fluid pan and all traces of gasket material.
See Figure.
- Remove the output speed sensor.
- Remove the screw from the output speed sensor securing bracket and pull the sensor clear.
- Disconnect the harness multiplug.
NOTE: M6 fixing.See Figure.
- Remove the screw from the output speed sensor securing bracket and pull the sensor clear.
- Disconnect the multiplug from the speed sensor. See Figure.