Air Temperature Control

Cooled air from the evaporator enters the heater assembly, where temperature blend doors direct a proportion of the air through the heater core to produce the required output air temperature.

The 2 temperature blend doors operate independently to enable individual temperature settings for the left and right sides of the cabin. The temperature blend doors are operated by stepper motors, which are controlled by the automatic temperature control (ATC) module using local interconnect network (LIN) bus messages.

The automatic temperature control (ATC) module calculates the temperature blend stepper motor positions required to achieve the selected temperature and compares it against the current position. If there is any difference, the automatic temperature control (ATC) module signals the stepper motors to adopt the new position.

Air temperature is controlled automatically unless maximum heating (HI) or maximum cooling (LO) is selected. When maximum heating or cooling is selected, a 'comfort' algorithm in the automatic temperature control (ATC) module adopts an appropriate strategy for air distribution, blower speed, and air source.

Temperature control of one side of the cabin can be compromised by the other side of the cabin being set to a high level of heating or cooling. True maximum heating or cooling (displayed as 'HI' or 'LO' on the TSD) can only be selected from the driver's side temperature control button. If 'HI' or 'LO' is selected from the driver's side, the passenger side temperature will be automatically set to match the driver's side.

When economy mode is selected by pressing the 'ECON' TSD soft button, no cooling of the intake air will take place. The minimum output air temperature from the system will be ambient air temperature plus any heat pick up in the air intake path.