Control Unit & Sensor Check
- Disconnect coil wire from distributor cap. Attach a test spark plug to coil wire. If plug is not available, hold coil wire 1/2" from engine block, using insulated pliers. Turn ignition on.
- Disconnect 4-wire connector from control unit. Watch for spark at test plug as connector is separated. If no spark occurs, proceed to step 6). If spark occurs, turn ignition off and disconnect 4-wire connector at control unit.
- Attach ohmmeter between the Orange and Purple wire terminals "D2" and "D3" of harness connector. Ohmmeter reading should be 400-800 ohms. If reading is correct, proceed to step 6). If reading is not correct, separate and connect 3-wire connector at the distributor. If ohmmeter reading is now correct, proceed to next step.
- If reading is still incorrect, separate 3-wire connector at distributor. Attach ohmmeter leads between Orange and Purple wire terminals "B2" and "B3" of distributor connector. If resistance is 400-800 ohms, repair harness between 3-wire and 4-wire connectors. If reading is still out of specification, replace pick-up coil.
- With ignition off and 4-wire connector separated, attach ohmmeter leads to negative battery terminal and Black wire terminal "D1" in harness connector. Ohmmeter should read nearly zero. If ohmmeter reading is okay, recheck system starting at step 3).
- If continuity exists, check ground screw in distributor to Black wire terminal "D1" and ground cable resistance. Turn ignition on and connect voltmeter to harness side of 4-wire connector Orange and Violet wire terminals "D2" and "D3". Voltmeter reading should fluctuate while cranking engine.
- If no voltage fluctuation occurs, check for defective trigger wheel, distributor shaft not turning, or missing trigger wheel retaining pin (shaft turning but not trigger wheel).