VER-1: Verification Procedure VER-1

Inspect vehicle to ensure that all components are connected. Reassemble and reconnect components as necessary. Attempt to start engine. If engine does not start, perform NO START TEST NS-1A: CHECKING FOR FAULT MESSAGES & SPARK  .

If engine starts and the engine controller has been replaced, perform the following steps.

1. If vehicle is equipped with a factory theft alarm system, start vehicle at least 20 TIMES so that the theft alarm system may be activated when desired.
2. Write (transfer) EMR mileage into new engine controller. See EMISSION MAINTENANCE REMINDER (EMR) MILEAGE TRANSFER  .
3. The no start condition has been corrected. The repair procedure is now complete. If engine starts and the engine controller has NOT been replaced, perform the following steps:
4. Connect DRB-II to engine diagnostic connector and erase faults.
5. The no start condition has been corrected and the fault messages have been erased. The repair procedure is now complete.