LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1995 >> Wrangler S, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 19A - Testing Estimated Time Function
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 19A - Testing Estimated Time Function

NOTE: Perform TEST VER-1B  after each repair.
CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
  1. Disconnect Body Control Module (BCM) Blue connector. BCM is located behind left side knee panel. Check condition of connector, and clean or repair connector as necessary. If connector is okay, go to next step.
  2. Turn ignition on, engine off. Using scan tool in voltmeter mode, check voltage on BCM Blue connector terminal No. 11 (Dark Blue wire). If voltage is less than 10 volts, repair open Dark Blue wire. If voltage is more than 10 volts, replace BCM.
scientia non olet · About LEMON Manuals