LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Cherokee Classic, 2D Pickup >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self Diagnostics >> Diagnostic Tests >> DTC P0157: 2/2 O2 Sensor Shorted To Ground (4.0L With CALIF. Emissions) >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0157: 2/2 O2 Sensor Shorted To Ground (4.0L With CALIF. Emissions): Testing

CAUTION: To diagnose this DTC properly, manufacturer recommends allowing vehicle to sit overnight in order to have a totally cold engine. At time of testing, coolant temperature must be within 10 degrees of ambient air temperature or test results may not be accurate.
NOTE: 2/2 HO2S is located in rear exhaust pipe below front mini-catalytic converter.
  1. Using scan tool, read DTCs. If DTC SPECIFIC GOOD TRIP counter is displayed and displayed count is "0", go to next step. If DTC SPECIFIC GOOD TRIP counter is not displayed or displayed count is not "0", go to step  6 .
  2. Turn ignition on, with engine off. Using scan tool, read and record 2/2 HO2S voltage. Disconnect 2/2 HO2S connector and note voltage reading. If voltage changes from less than one volt to about 5 volts, replace 2/2 HO2S. If voltage does not change from less than one volt to one volt or more, go to next step.
  3. Turn ignition off. Disconnect PCM connectors. PCM is located on firewall in right rear corner of engine compartment. Visually inspect connectors for corroded, damaged, pushed-out or miswired terminals. Repair connectors as necessary. If connectors are okay, measure resistance between Tan wire and Brown/Yellow wire at 2/2 HO2S connector. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, Tan wire is shorted to Brown/Yellow wire. Repair wiring as necessary.
  4. Measure resistance between ground and Tan wire at 2/2 HO2S connector. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground in Tan wire between PCM and 2/2 HO2S.
  5. At this time, PCM is assumed to be defective. Replace PCM.
  6. Turn ignition off. Visually inspect related connectors and wiring harness for damage. Repair connectors and wiring harness as necessary. If connectors and wiring harness are okay, reconnect all connectors. Start engine. Wiggle 2/2 HO2S connector and wiring harness while monitoring scan tool display. If GOOD TRIP counter display count changes to "0", repair connector or wiring harness where wiggling caused display to change. If GOOD TRIP counter display count does not change to "0", no problem is indicated at this time. Check for any related technical service bulletins that may apply.
scientia non olet · About LEMON Manuals