LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Cherokee Limited, 2D Pickup >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Programming >> Sentry Keys >> Programming Blank Sentry Keys Using Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Blank Sentry Keys Using Scan Tool

  1. Once key blank is cut, insert key into ignition switch. Turn ignition on.
  2. Using scan tool, select THEFT ALARM, then SKIM. Select MISCELLANEOUS.
  3. Using scan tool, select PROGRAM NEW KEY.
  4. Enter 4-digit Personal Identification Number (PIN) code.
  5. When programming is completed, Sentry Key Immobilizer Module (SKIM) will exit SECURED ACCESS mode and display status of key. One of 5 different status messages may be displayed as follows:

    • PROGRAMMING SUCCESSFUL

      will be displayed if SKIM smart key programming succeeds.

    • LEARNED KEY IN IGNITION

      will be displayed if key in the ignition has already been programmed into vehicle's SKIM.

    • 8 KEYS ALREADY LEARNED, PROGRAMMING NOT DONE

      will be displayed if 8 keys have already been programmed into SKIM. If a new key needs to be added due to a lost or defective key, the ERASE ALL KEYS function has to be performed. Original 7 keys plus additional new key may then be reprogrammed into SKIM.

    • PROGRAMMING NOT ATTEMPTED

      will be displayed after an ERASE ALL KEYS function is executed.

    • PROGRAMING KEY FAILED

      will be displayed if further diagnosis is required.
  6. To program additional keys, turn ignition off. Remove current programmed key and insert next new blank key. Turn ignition switch to RUN position. Re-enter SECURED ACCESS mode function and go to step  1 .
scientia non olet · About LEMON Manuals