LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Sentry Key Immobilizer System >> PCM Status Failure, Rolling Code Failure Or Serial Link External Fault
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PCM Status Failure, Rolling Code Failure Or Serial Link External Fault

  1. Using scan tool, read and record Sentry Key Immobilizer Module (SKIM) Diagnostic Trouble Codes (DTC). Erase SKIM DTCs. Turn ignition off for 10 seconds. Turn ignition on. Read SKIM DTCs. If same fault message is currently displayed, go to next step. If same fault message is not currently displayed, go to step  4 .
  2. Visually inspect related wiring and harness connectors for corrosion, pullout and damage. Repair problems as necessary. Check for related technical service bulletins. If no problems were found, go to next step. If any problem was found, repair as necessary.
  3. Replace SKIM. Erase SKIM DTCs. Drive vehicle. Perform several key cycles. Read SKIM DTCs. If same fault message is currently displayed, replace Powertrain Control Module (PCM). If same fault message is not currently displayed, test is complete.
  4. Visually inspect related wiring and harness connectors for corrosion, pullout and damage. Repair problems as necessary. Check for related technical service bulletins. If no problems were found, test is complete. If any problem was found, repair as necessary.
scientia non olet · About LEMON Manuals