Air Bag Verification Test

WARNING: DO NOT reconnect battery before turning ignition switch to ON position and ensuring no one is in vehicle. Air bag may deploy.

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. Connect scan tool to Data Link Connector (DLC). See Figure . Turn ignition switch to ON position. Using scan tool, erase all DTCs. Turn ignition switch to OFF position and wait 15 seconds.

NOTE: If vehicle is equipped with passenger's side air bag on/off switch, record DTCs with switch in both directions.

Turn ignition switch to ON position and wait one minute. Read and record DTCs. If no DTCs are reset, repair is complete. If any DTCs reset, perform appropriate test in accordance with DTC retrieved. See DIAGNOSTIC TROUBLE CODE DEFINITIONS table under SELF-DIAGNOSTIC SYSTEM.