TCM Quick Learn Procedure

The quick learn procedure requires the use of the DRBIII(R) scan tool. This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn procedure should be performed if any of the following procedures are performed:

• Transmission Assembly Replacement
• Transmission Control Module Replacement
• Solenoid Pack Replacement
• Clutch Plate and/or Seal Replacement
• Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

• Brakes must be applied.
• The engine speed must be above 500 RPM.
• Throttle Position (TP) must be less than 3 degrees.
• The shift lever position must stay in PARK until prompted to shift to overdrive.
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII(R) indicates the procedure is complete.
• Oil temperature must be 60-200°F (15-93°C).

To perform quick learn procedure, select TRANSMISSION, MISCELLANEOUS, then QUICK LEARN on scan tool. Follow on-screen instructions. Ensure conditions listed have been met or procedure may abort.