Flash To Pass Inoperative

Possible Causes are:

The High Beam Headlamps must be operational for the result of this test to be valid. Disconnect the left multi-function switch harness connector. Measure the voltage of the High Beam Relay control circuit in the left multi-function switch connector. Is the voltage more than 10 volts? If yes, replace the Left Multi-Function Switch. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS. If no, go to next step.
Turn ignition off. Disconnect the left multi-function switch connector. Disconnect the Junction Block C3 harness connector. Using an ohmmeter measure the High Beam Relay control circuit from the left multi-function switch connector to the Junction Block C3 connector. Was the resistance less than 5 ohms? If yes, replace the Junction Block. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS. If no, repair the High Beam Relay Control circuit for an open. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS.