Passenger Rear Window Inoperative From Rear Switch
Possible Causes are:
- OPEN GROUND CIRCUIT
- SWITCH DEFECTIVE
Ensure the Window Lock Out Switch on the DDM is operating properly before proceeding. Remove the Rear Door Trim Panel. Disconnect the Power Window Switch connector. Turn ignition off. Turn all lights off. Measure the resistance of the Ground circuit to ground. Is the resistance less than 5 ohms? If yes, replace the Power Window Switch. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS. If no, repair the open ground circuit. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS.