NO FUSE In VF Display

Possible Causes:

• Fused B+ Circuit To Ground
• Fused B+ Circuit Open
• Instrument Cluster

Testing

1. Turn ignition off. Check fuse No. 24 (10-amp) in Power Distribution Center (PDC), located in right side of engine compartment, next to battery. If fuse is okay, go to next step. If fuse is faulty, repair short to ground on power feed circuit. See POWER DISTRIBUTION in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
2. Remove instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Check voltage between instrument cluster harness connector C1 terminal No. 8 (Pink/White wire) and ground. See Figure . If battery voltage exists, replace instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. If battery voltage does not exist, repair open Pink/White wire.