LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2002 >> Wrangler SE, Standard >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Verification Tests >> Air Bag Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Air Bag Verification Test

  1. Connect scan tool. Remove all jumper wires used during testing. Reconnect all disconnected components, except battery. Turn ignition on, then reconnect battery.
  2. Using scan tool, clear all stored Diagnostic Trouble Codes (DTC). Turn ignition off. After 15 seconds, turn ignition on. Wait one minute. Recheck active and stored codes. If vehicle is equipped with passenger air bag ON/OFF switch, check for DTCs with switch in each position. If Powertrain Control Module (PCM) has been changed, a DTC will be set in Anti-Lock Brake System (ABS) and air bag modules. Enter correct mileage and Vehicle Identification Number (VIN) in PCM. Clear DTCs from ABS and air bag modules.
  3. If any DTCs exist, diagnose and repair system as necessary. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals