Fuel Pump Module: Installation
Fuel tank removal will be necessary for fuel pump module removal.
CAUTION:
Whenever the fuel pump module is serviced, the module gasket must be replaced.
- Thoroughly clean locknut threads and mating fuel tank threads. Use a soap/water solution. Do not use carburetor cleaner to clean threads.
- Using new gasket, position fuel pump module into opening in fuel tank.
- Apply clean water to locknut threads.
- Position locknut over top of fuel pump module.
- Rotate module until arrow is pointed toward front of vehicle (12 o'clock position). This step must be done to prevent float/float rod assembly from contacting sides of fuel tank.
- Install Special Tool 6856 to locknut.
- Tighten locknut to 74 N.m (55 ft. lbs.) torque.
- Rotate fuel filter/fuel pressure regulator until its fitting is pointed to 10 o'clock position.
- Install fuel tank. See FUEL TANK .