Fuel Tank

Fig 1: Fuel Tank Mounting

Courtesy of CHRYSLER LLC

If fuel tank is to be replaced, install fuel pump module into tank. See INSTALLATION .
Position fuel tank to hydraulic jack.
Raise tank until positioned to body.
Install and tighten bolts (1) (2) and (3). See SPECIFICATIONS .
Remove hydraulic jack.

Fig 2: Fuel Tank Fuel/EVAP Lines
Courtesy of CHRYSLER LLC
Connect EVAP, ORVR, fuel and NVLD lines at front and rear of tank.
Connect fuel pump module electrical jumper connector (5) to body connector (6).

Fig 3: Fuel Filler Tubes And Hoses To Fuel Tank
Courtesy of CHRYSLER LLC
Connect rubber fill hose (3) to tank fitting (7) and tighten clamp (9).
Lower vehicle.
Fill fuel tank with fuel.
Start engine and check for fuel leaks near top of module.