Throttle Control Cable - 4.7L

Fig 1: View Of Accelerator Cable Release Tab - 4.7L V-8

Courtesy of CHRYSLER LLC

Slide accelerator cable plastic mount into bracket. Continue sliding until tab (3) is aligned to hole in mounting bracket. See Fig 1.
Route accelerator cable over top of cable cam.
Connect cable end to throttle body bellcrank pin (snaps on rearward).
Slide rubber grommet away from plastic cable housing.

Fig 2: Throttle Control Cable
Courtesy of CHRYSLER LLC
Install rubber grommet (3) into dash panel until seated. See Fig 2.
Push cable housing into rubber grommet and through opening in dash panel.
From inside vehicle, slide throttle cable core wire into opening (6) in top of pedal arm.
Push cable retainer (clip) (2) into pedal arm opening until it snaps in place.
Snap cable into dash panel routing clip.
Install air resonator tube to throttle body.
Before starting engine, operate accelerator pedal to check for any binding.