Cleaning Fuel Injectors

NOTE: Before cleaning the injector recesses, seal the injector holes in the injector recesses with the appropriate pin to prevent debris from falling into the recesses and entering the motor.

Seal the injector holes inside the cylinder head recesses.
Wipe out injector recesses with a non-woven cloth, then clean with a cylinder brush.
Clean the bottom of the cylinder recess with a round brush.
Blow out the recess and clean again with a non-woven cloth and cover over.
Perform these steps for each injector recess.
NOTE: DO NOT clean the tip of the injector with a wire brush. Use a non - woven cloth.
Clean injector body with a wire brush.
Clean injector tips with a non-woven cloth.
NOTE: Do Not apply antiseize lubricant to the injector nozzle area.
Grease injector body with anti seize lubricant.

NOTE: Always replace the seals that seal off the injectors at the cylinder head to the combustion chamber and replace the retaining screws.