Diagnostic Test
- *AIRBAG SYSTEM VERIFICATION TEST - VER 1
- Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.
- Connect the scan tool to the Data Link Connector - use the most current software available.
- With the scan tool, erase stored DTCs in all Airbag System Modules.
- Turn the ignition off, and wait 30 seconds, then turn the ignition on.
- Wait one minute, and read active DTCs in all Airbag System Modules.
- Read the stored DTCs in all Airbag System Modules.
WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.Are any DTCs present or if the original condition still present?
Yes
- Repair is not complete. Select the appropriate diagnostic procedure from the DIAGNOSTIC CODE INDEX .
No
- Repair is complete.