LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2008 >> Compass Limited, FWD, Automatic CVT >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Delivery-Gas >> Module - Fuel Pump >> Installation >> Module - Fuel Pump
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module - Fuel Pump

NOTE: The pump has to be properly located to the tank for the fuel gauge to work properly.
Fig 1: Fuel Pump Module Seal
GC0041455Courtesy of CHRYSLER LLC
  1. Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.
    Fig 2: Removing/Installing Module
    GC0055420Courtesy of CHRYSLER LLC
  2. Install module.
    Fig 3: Location Tab
    GC0055419Courtesy of CHRYSLER LLC
  3. Position fuel pump module in tank. Make sure the alignment tab lines up on the fuel tank and pump module for Gas or Diesel fuel tanks.
    Fig 4: Lock Ring Tool
    GC0055418Courtesy of CHRYSLER LLC
  4. While holding the pump module in position, install lock ring and use special tool Spanner Wrench #9340 to tighten lock ring.
    Fig 5: Module Cover
    GC0055414Courtesy of CHRYSLER LLC
  5. Install plastic cover.
    Fig 6: Cushion Loose
    GC0055413Courtesy of CHRYSLER LLC
  6. Install rear cushion.
    Fig 7: Rear Seat In Place
    GC0055417Courtesy of CHRYSLER LLC
  7. Install the negative battery cable.
  8. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
  9. Fill fuel tank with clean fuel. Use the Scan Tool to pressurize the system and check for leaks.


Fig 1: Fuel Pump Module Seal
GC0041455Courtesy of CHRYSLER LLC
NOTE: The pump has to be properly located to the tank for the fuel gauge to work properly.
  1. Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.
    Fig 2: Siphon Line For AWD
    GC0055423Courtesy of CHRYSLER LLC
  2. Connect line to module.
    Fig 3: Removing/Installing Module
    GC0055420Courtesy of CHRYSLER LLC
  3. Install fuel pump module.
    Fig 4: Location Tab
    GC0055419Courtesy of CHRYSLER LLC
  4. Position fuel pump module in tank. Make sure the alignment tab lines up on the fuel tank and pump module for Gas or Diesel fuel tanks.
    Fig 5: Lock Ring Tool
    GC0055418Courtesy of CHRYSLER LLC
  5. While holding the pump module in position, install lock ring and use special tool Lock Ring #9340 to tighten lock ring.
    Fig 6: Module Cover
    GC0055414Courtesy of CHRYSLER LLC
  6. Install plastic cover.
    Fig 7: Small Module Cover
    GC0055425Courtesy of CHRYSLER LLC
  7. Connect electrical connector (2).
    Fig 8: Cushion Loose
    GC0055413Courtesy of CHRYSLER LLC
  8. Install rear cushion.
  9. Install the negative battery cable.
  10. Fill fuel tank with clean fuel. Use the Scan Tool to pressurize the system and check for leaks.
scientia non olet · About LEMON Manuals