Scan Tool Data - Front Control Module (FCM)
The following chart lists data values taken from the Scan Tool Front Control Module (FCM) data list. The data is to be used for reference only.
The following data values were recorded under the following conditions unless otherwise specified:
- Key On, Engine Off
- No DTCs set
- Engine at operating temperature
- Vehicle in Park or Neutral
- Doors Closed
- Accessories Off
- Altitude at 297.2 meters (975 ft.) above sea level
Not all of the scan tool data is applicable and may vary as much as 20 percent due to the following:
- Vehicle age and wear
- Altitude
- Weather
- Engine, Transmission and other Vehicle Options
- Aftermarket Accessories
There are footnotes located next to some values in the data table to reference specific conditions or additional information. They are listed in detail after the data table.
| Scan Tool Data - FCM | ||
|---|---|---|
| Data Name | Value | Unit or State |
| 5 V A/D Voltage Supply Sense | 4.95 | Volts |
| AC Refrigerant Pressure | 6 (87) | bar (psi) |
| AC Refrigerant Pressure Voltage | 0.9 | Volts |
| Adjustable Pedals Relay | Off | On/Off |
| Ambient Temperature Degrees | 22 (71.6) | °C (°F) |
| Ambient Temperature Voltage | 1.98 | Volts |
| Analog Hood Ajar | Hood Open / Switch Closed | Hood Open / Switch Closed/Hood Closed / Switch Open |
| Analog Hood Ajar Voltage | 0 | Volts |
| ASD Sense | False | True/False |
| Auto High Beam Active | False | True/False |
| Auto High Beam Duty Cycle | 0.0 | % |
| Battery Voltage | 13.3 | Volts |
| BCM SPAD Request | True | True/False |
| Brake Fluid Level | Normal | Normal/Low |
| Brake Fluid Level Voltage | 3.59 | Volts |
| Brake Switch | False | True/False |
| Charging System Failure | False | True/False |
| DDM SPAD Request | False | True/False |
| Driver Door Ajar | Closed | Closed/Ajar |
| Engine RPM | 0 | rpm |
| ESP Flash Request | False | True/False |
| Flipper Glass Ajar | Closed | Closed/Ajar |
| Front Fog Lamp Relay | Off | On/Off |
| Front Fog Request | False | True/False |
| Front Washer Request | False | True/False |
| Front Wiper Mist Request | False | True/False |
| Front Wiper On/Off Relay | Off | On/Off |
| Front Wiper Park Switch Sense | True | True/False |
| Front Wiper Switch | Intermittent 1 | Intermittent 1 - 6/Low Speed/High Speed |
| Hazard Switch | False | True/False |
| Headlamp Switch | Auto Position | Auto Position/Headlamp Position/Off Position/Parklamp Position |
| HFM SPAD Request | False | True/False |
| High Beam Steady Status Request | False | True/False |
| High Speed Rad Fan Duty Cycle | 0 | % |
| High Speed Rad Fan State | Off | On/Off |
| Horn Relay | Off | On/Off |
| Horn Request | False | True/False |
| Ignition Run/Acc/PAD Relay | On | On/Off |
| Ignition Run/Acc/SPAD Relay | On | On/Off |
| Ignition Run/Start Sense | True | True/False |
| Ignition Switch Status | RUN Position | (1) |
| Ignition Unlock/Run/Start State | On | On/Off |
| Impact Event Requiring Engine Stop | False | True/False |
| IOD Fuse Sense | True | True/False |
| Key in Ignition | True | True/False |
| Left Front Turn Lamp State | Off | On/Off |
| Left High Beam Duty Cycle | 0 | % |
| Left High Beam State | Off | On/Off |
| Left Low Beam Duty Cycle | 0 | % |
| Left Low Beam State | Off | On/Off |
| Left Rear Turn Lamp State | Off | On/Off |
| Left Trailer Tow Relay | Off | On/Off |
| Left Turn Signal Request | False | True/False |
| Lock Chirp Request (Lock Master) | False | True/False |
| Low Speed Rad Fan Duty Cycle | 0 | % |
| Low Speed Rad Fan State | Off | On/Off |
| Optical Horn Request | False | True/False |
| Panic Mode Active | False | True/False |
| Park Brake Switch Engaged | False | True/False |
| Park Lamp Relay | Off | On/Off |
| Passenger Door Ajar | Closed | Closed/Ajar |
| PDM SPAD Request | False | True/False |
| Power Inverter On Request | False | True/False |
| PRND Status | Park | (2) |
| Rad Fan #1 Duty Cycle | 0.0 | % |
| Rad Fan #2 Duty Cycle | 0.0 | % |
| Rainsensor Wiper Request | Off | On/Off |
| Reverse Fog Lamp Relay | Off | On/Off |
| Right Front Turn Lamp State | Off | On/Off |
| Right High Beam Duty Cycle | 0 | % |
| Right High Beam State | Off | On/Off |
| Right Low Beam Duty Cycle | 0 | % |
| Right Low Beam State | Off | On/Off |
| Right Rear Turn Lamp State | Off | On/Off |
| Right Trailer Tow Relay | Off | On/Off |
| Right Turn Signal Request | False | True/False |
| RKE Complex Function Request | No Complex RKE | (3) |
| Run/Start (Remote Start) | On | On/Off |
| Start (Remote Start) | Off | On/Off |
| Suppress Exterior Lighting | False | True/False |
| TPM Horn Chirp Request | False | True/False |
| Traction Control Button Pressed | False | True/False |
| Transmission Type | Automatic | Automatic/Manual |
| Unlock Chirp Request (Lock Master) | False | True/False |
| Vehicle Speed | 0 (0.0) | KM/H (MPH) |
| VTA Status | Disarmed | (4) |
| Washer Fluid Level | Normal | Normal/Low |
| Washer Fluid Level Voltage | 4.24 | Volts |
| Washer Motor State | Off | On/Off |
| Wheel Speed Front Left | 0.0 | rpm |
| Wheel Speed Front Right | 0.0 | rpm |
| Wheel Speed Rear Left | 0.0 | rpm |
| Wheel Speed Rear Right | 0.0 | rpm |
| Wiper Hi/Low Relay | Off | On/Off |
Footnotes
- Ignition Switch Status settings are ACC Position, LOCK Position, OFF Position, OFF/ACC Position, RUN Position, and START Position.
- PRND Status settings are Drive, Neutral, Not Reverse (Manual), Park, and Reverse.
- RKE Complex Function Request settings are Global Window Close, Global Window Open, Horn Chirp Toggle, No Complex RKE, Optical Chirp Toggle, and Sequential Unlock Toggle.
- VTA Status setting are Alarm - Lights and Horn, Alarm - Lights Only, Armed, Disarmed, Pre-Armed, Tamper Alert, and VTA ITM Alarm.