Throttle Body: Installation: Installation

Fig 1: Throttle Body Gasket

Courtesy of CHRYSLER LLC

Install a new intake manifold to throttle body gasket (2), if replacement was necessary.
Install four new four j-nuts (1), if replacement was necessary.

Fig 2: Throttle Body Bracket And Throttle Body Bolts
Courtesy of CHRYSLER LLC

CAUTION:
DO NOT OVER TORQUE. Over tightening can cause damage to the throttle body, gaskets, bolts and/or the intake manifold.
Install throttle body (4) to intake manifold.
Install throttle body support bracket (3), bolt (2) and tighten bracket bolt to 25 N.m (18 ft. lbs.).
Install four bolts (1) and hand tighten.

Fig 3: Throttle Body Mandatory Torque
Courtesy of CHRYSLER LLC

CAUTION:
The throttle body must be torqued in a mandatory torque sequence. Tighten in a criss - cross pattern to specification.
Tighten the bolts in a mandatory torque criss - cross pattern sequence to 7.5 N.m (65 in. lbs.).

Fig 4: World Eng Electrical Connector
Courtesy of CHRYSLER LLC
Connect electrical connector (1) to throttle body (2).
Install clean air hose and tighten clamps to 4 N.m (35 in. lbs.).
Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
Use a scan tool and clear all fault codes then perform the ETC RELEARN function.