MODULE, Steering Column Control: Installation: Installation: SCCM

Fig 1: Multi-function Switch Mounting

Courtesy of CHRYSLER LLC

Position the SCCM (3) over the steering column shaft (2).
Install the three screws (1).

Fig 2: Locating Sccm Electrical Connectors
Courtesy of CHRYSLER LLC
Connect the electrical connectors (2) to the instrument panel harness, ensure wiring is properly routed. Then check that the connectors, locking tabs are properly engaged.
Install steering column shrouds. Refer to SHROUD, Steering Column, Lower, Installation & SHROUD, Steering Column, Upper, Installation . Be sure all wires are inside of shrouds.
Install steering wheel ensuring the flats on hub align with the clockspring. Refer to WHEEL, Steering, Installation . Pull the airbag leads through the larger slot. Ensure leads do not get pinched under the steering wheel.
NOTE:
There is a small wire harness in the steering wheel and it contains the horn circuits and speed control circuits.
Connect the speed control and horn wire connector into the clockspring.
Pull the grenade pin out of the clockspring.
Install the driver airbag, Refer to AIR BAG, Driver, Installation .

WARNING:

Do not connect the negative battery cable at this time. Perform the Air Bag System Test prior to connecting the negative battery cable. Refer to Diagnosis and Testing . Failure to follow this warning may result in accidental air bag deployment and possible serious or fatal injury.