Programming and Relearning

STANDARD PROCEDURE - DRIVE MOTOR TEACH PROCEDURE

REPLACEMENT DRIVE MOTOR

1. Upon first powering up the sunroof, continuously press the close button on the power sunroof switch. The sunroof will begin moving in the tilt up direction.
2. The glass panel will move to the hard stop (just past the full tilt position) and then reverse to the soft stop (the full tilt position).
3. Once the sunroof has reversed immediately (within 5 seconds of stopping travel), release the switch and continuously press the close button again.
4. The sunroof glass will continue to move to the fully closed position. Once fully closed the close button can be released.

ORIGINAL DRIVE MOTOR

1. Cycle the sunroof to full close position and release close button on the power sunroof switch.
2. Once the sunroof is in the fully closed position, press and continuously hold the close button again.
3. After a ten second delay the sunroof will begin to move past the normal vent position to the hard stop position. It will then reverse to the normal full vent position (also called the soft stop).
4. Once the sunroof has reversed to the vent soft stop, immediately (within 5 seconds of stopping travel) release the close button and continuously press it again.
5. After a three second delay the sunroof glass will continue to move to the fully closed position. Once fully closed the close button can be released.