Radiator, Engine Cooling: Removal: 5.7L/6.4L

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 1: Lower Splash Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove bolts (1) and the belly pan.
Drain the cooling system. Refer to STANDARD PROCEDURE .
Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L or BODY, AIR CLEANER, REMOVAL, 6.4L .
Remove the upper radiator hose.

Fig 2: Lower Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Remove the lower radiator hose (1).
Remove the radiator fan assembly. Refer to FAN, COOLING, REMOVAL .
Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
Remove support and lower the vehicle.

Fig 3: Upper Radiator Mounting Brackets & Bolt
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Bolts are installed with threadlocker. Use hand tools to remove the upper radiator mounting bolts.
Remove bolts (3) and the upper radiator isolator (1).

Fig 4: Support Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the lower condenser mounting bolts.
Remove the bolt (2) located between the cooler lines.
Using a suitable hanger. Support the condenser and remove the right side upper mounting bolt.

Fig 5: Upper Shroud Cover, Pick & Clip
Courtesy of CHRYSLER GROUP, LLC
Carefully remove the upper shroud cover (2) by using a pick (3) to pull the cover retaining hole away from the clip (1) along the edge.
Tilt radiator toward engine and remove the radiator from vehicle.