Standard Procedure - Hoisting: Notes

Refer to the Owner's Manual for emergency vehicle lifting procedures.

When properly positioned, a floor jack can be used to lift the vehicle. Support the vehicle in the raised position with jack stands at the front and rear ends of the frame rails.

Fig 1: Lift Contact Points

Courtesy of CHRYSLER GROUP, LLC

1 -	Frame Contact Lift (Single Post)
	Chassis Lift (Non-Axle Dual Post)
	Outboard Lift (Dual Post)
	Floor Jack
2 -	Floor Jack

CAUTION:

Do not attempt to lift the vehicle with a floor jack positioned under:

A body side sill.
A steering linkage component.
A drive shaft.
The engine or transmission oil pan.
The fuel tank.
A front suspension arm.
Transfer case.

NOTE:

Use the correct sub-frame rail or frame rail lifting locations only.