LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2013 >> Compass Limited, FWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Totally Integrated Power Module (TIPM) >> Standard Procedure >> Standard Procedure - Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Procedure - Programming

  1. Install a battery charger.
  2. Verify that the charging rate provides approximately 13.5 volts.
    NOTE:

    Do not allow the charger to time out during the reconfiguration process. Set the battery charger timer (if so equipped) to continuous charge.

  3. Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop.
  4. Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
  5. Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
  6. Select "ECU View".
  7. Select "TIPMCGW" or "FCMCGW".
  8. Select "MISC".
  9. Select "Restore Vehicle Configuration".
  10. Follow prompts on StarSCAN to complete the reconfigure procedure.
  11. Once complete, Wait one minute and turn the ignition key to the "OFF" position.
  12. Remove the StarSCAN unit, cable and charger from the vehicle.
  13. Verify proper operation.
scientia non olet · About LEMON Manuals