LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Pump, Water >> Removal >> Diesel
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pump, Water: Removal: Diesel

Fig 1: Power Steering Pressure Line Retaining Bracket Bolt
GC0137795Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Drain the power steering fluid.
  3. Raise and support the vehicle.
    NOTE:

    Drain the fluid in a clean container, free of debris. Save the fluid for re-use.

  4. Drain the cooling system. Refer to STANDARD PROCEDURE .
  5. Remove the accessory drive belt (1). Refer to BELT, SERPENTINE, REMOVAL .
  6. Loosen the band clamps (4) and disconnect the coolant return hose from the water pump (3).
  7. Remove the power steering line retaining bracket bolt (2).
    Fig 2: Vacuum Lines, Coolant Inlet Hose, Power Steering Pump Supply Hose & Vacuum Switch Connector
    GC0137796Courtesy of CHRYSLER GROUP, LLC
  8. Remove the coolant inlet hose (2) at the pump.
  9. Remove the thermostat bypass hose at the pump.
  10. Remove the power steering pump supply hose (1) at the pump.
  11. Remove the power steering vacuum lines (3).
  12. Disconnect the electronically controlled vacuum switch connector (4).
    Fig 3: Pressure Line At Pump
    GC0137797Courtesy of CHRYSLER GROUP, LLC
  13. Remove the power steering pressure line (2).
  14. Remove the water/power steering pump support bracket bolt.
  15. Remove the water/power steering pump mounting bolts (1).
  16. Remove the water/power steering pump (3).
scientia non olet · About LEMON Manuals