1/1 Exhaust

Fig 1: Cam Sensor

Courtesy of CHRYSLER GROUP, LLC

Lubricate sensor o-ring.
Install sensor utilizing twisting motion. Make sure sensor is fully seated. Do not drive sensor into the bore with screw. This can cause sensor to be incorrectly seated causing engine to fail.
Install mounting bolt and tighten to 9 N.m (79.5 in. lbs.).

Fig 2: Rear Cam Sensor Shield Removed
Courtesy of CHRYSLER GROUP, LLC
Carefully attach electrical connector to camshaft position sensor. Feel for positive lock (click). Installation at angle may damage the sensor pins.
Install heat shield onto mounting stud.
Install heat shield retaining nut and tighten.

Fig 3: Rear Cam Sensor Shield Installed
Courtesy of CHRYSLER GROUP, LLC
Connect negative battery cable.

NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components. Refer to STANDARD PROCEDURE .