Fuel Tank

Fig 1: Fuel Tank

Courtesy of CHRYSLER GROUP, LLC

The fuel tank is made from High Density Polyethylene (HDPE) material and is located near the rear center of the vehicle. The primary fuel pump module is located on the top left side of the fuel tank. All Wheel Drive (AWD) vehicles have a saddle style fuel tank that has a reservoir on both sides of the driveshaft and a secondary fuel pump module on the top right side of the fuel tank. The fuel tank contains the following components:

• Primary fuel pump module
• Secondary fuel pump module (AWD)
• Fuel tank vent (check valve)
• Control valve
• Inlet check valve

The primary and secondary (AWD) fuel pump modules are the only serviceable components of the fuel tank. If the fuel tank vent, control valve or inlet check valve requires service, the fuel tank must be replaced as an assembly.

The fuel tank vent, control valve and inlet check valve are components of the evaporative emissions system (Refer to EVAPORATIVE EMISSIONS ).