Removal & Installation
WARNING: This page is about the Compass Latitude, Eng CD ED6, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 4WD,Standard Trans | DOES NOT include wheel alignment. Includes: Bleed Clutch System. | 10.3 | C | |
| Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace: | ||||
| Standard Trans | 0.4 | C | ||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| Standard Trans, Concentric Slave Cylinder (CSC) | 0.2 | C | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Replace: | ||||
| Standard Trans, Rear,w/Clutch Assembly Removed | 0.8 | B | ||
| Combination Procedure: DIFFERENTIAL OUTPUT SEAL: Replace: | ||||
| Standard Trans, Axle Shaft Oil Seal,Each | 0.2 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Standard Trans, w/Clutch Assembly Removed | 0.5 | C | ||
| Combination Procedure: INPUT SHAFT SEAL: Replace: | ||||
| Standard Trans | 0.5 | B | ||
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| Standard Trans | 0.5 | C | ||