Removal And Installation: Rear: Installation
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
The rear right and rear center seat belt buckles are serviced individually; however, the rear center lower anchor and rear left buckles are serviced only as a unit.
- Position the rear seat belt buckle unit (2) onto the rear floor panel.
- Install and tighten the screw or screws (1) that secure the rear seat belt buckle anchor to the rear floor panel. Tighten the screws to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the rear seat cushion into the vehicle. Refer to SEAT CUSHION, REMOVAL AND INSTALLATION .