Solenoid, Variable Valve Timing: Installation: Left
- Install the variable valve timing solenoid seals (1). The seals can be reused if not damaged.
- Refer to the markings made at disassembly and install the intake variable valve timing solenoid (4) and the exhaust variable valve timing solenoid (2) in their original locations.
- Install the variable valve timing solenoid mounting bolts (3) and tighten to 4 N.m (35 in. lbs.).
- Connect the electrical connector (1) to the variable valve timing solenoid.
- Install the air inlet hose (3) to the air cleaner body and the throttle body. Tighten the clamps (1) and (4) to 4 N.m (35 in. lbs.).
- Connect the electrical connector (2) to the Inlet Air Temperature (IAT) sensor.
- Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
NOTE:
The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components.