Removal And Installation

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

The heated steering wheel switch, located in the Uconnect® touch screen, cannot be adjusted or repaired. If a heated steering wheel switch or indicator lamp is inoperative or damaged, the entire Uconnect® touch screen must be replaced. Refer to MODULE, RADIO RECEIVER, REMOVAL AND INSTALLATION .