Wheel Alignment Setup
- Position the vehicle on an alignment rack.
- Install all required alignment equipment on the vehicle, per the alignment equipment manufacturer's instructions. On this vehicle, a four-wheel alignment is recommended.NOTE:
Prior to reading the vehicle's alignment readouts, the front and rear of vehicle should be jounced. Induce jounce (rear first, then front) by grasping the center of the bumper and jouncing each end of vehicle an equal number of times. The bumper should always be released when vehicle is at the bottom of the jounce cycle.
- Read the vehicle's current front and rear alignment settings. Compare the vehicle's current alignment settings to the vehicle specifications for camber, caster and toe-in. Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
- Refer the information later in this procedure, and perform the alignment in the following order:
- Rear Camber
- Rear Toe
- Front Camber
- Front Toe