LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> Removal And Installation >> LHD >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: LHD: Installation

GC0192775Courtesy of CHRYSLER GROUP, LLC
  1. Position the Electric Hydraulic Power Steering (EHPS) pump (2) on the EHPS pump bracket.
  2. Install the three EHPS pump bracket nuts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
  3. Position the EHPS pump in vehicle.
    GC0192893Courtesy of CHRYSLER GROUP, LLC
  4. Tighten the two power steering pump bracket frame bolts (2) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
    NOTE:

    Make sure the O-ring is clean and seats properly. 

  5. Install the EHPS pressure line (4) into the pump.
  6. Install EHPS pump pressure line bolt (3) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
    GC0192983Courtesy of CHRYSLER GROUP, LLC
  7. Connect the return line (3) to the EHPS pump and ensure the hose clamp is securely positioned.
  8. Connect the supply line (1) to the EHPS pump and ensure the hose clamp is securely positioned.
  9. Install the right front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
    GC0192668Courtesy of CHRYSLER GROUP, LLC
  10. Connect the two EHPS pump wire harness connectors (2) and secure the wiring harness routing clips in the EHPS pump.
  11. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
  12. Remove the supports and lower the vehicle.
  13. Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECTION .
  14. Refill the power steering fluid and bleed the system. Refer to POWER STEERING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals