LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Cherokee Trailhawk >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Module, Power Inverter >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Power Inverter: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0162274Courtesy of CHRYSLER GROUP, LLC
  2. Unsnap the upper end of the floor duct (1) from the outlet on the left end of the heater and air conditioner distribution housing. Refer to DUCT, FLOOR DISTRIBUTION, REMOVAL .
  3. Remove the electrical connector from the Power Inverter Module (PIM).
    GC0162332Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fastener (1) for the PIM bracket next to the ventilation door motor (2).
    GC0162280Courtesy of CHRYSLER GROUP, LLC
  5. Remove the PIM bracket arm fastener (1).
    GC0162208Courtesy of CHRYSLER GROUP, LLC
  6. Remove the PIM and bracket from the vehicle.
  7. Remove both upper (1) and lower (2) fasteners to separate the PIM from the bracket.
scientia non olet · About LEMON Manuals