LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Cherokee Trailhawk >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Column >> Wheel, Steering >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wheel, Steering: Removal

WARNING:
  • Do not place a non-deployed airbag face down on a hard surface. The airbag will propel into the air if accidentally deployed. Failure to follow this instruction may result in possible serious or fatal injury.
  • Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. This will disable the airbag system. Failure to follow this instruction may result in accidental airbag deployment and possible serious or fatal injury.
  • Allow the airbag system capacitor to discharge for two minutes before removing the steering wheel or any airbag system component. Failure to follow this instruction may result in accidental airbag deployment and possible serious or fatal injury.
  1. Adjust the steering wheel so that the tires are in the STRAIGHT-AHEAD position.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the driver airbag. Refer to AIR BAG, DRIVER, REMOVAL .
  4. Disconnect the wire harness connectors from the Steering Column Control Module (SCCM).
    CAUTION:

    Do not bump or hammer on the steering wheel or steering column shaft when removing the steering wheel.

    CAUTION:

    Do not attempt to rotate the clockspring rotor once the steering wheel is removed. The clockspring must remain centered in its travel to avoid overextending the clockspring inner parts, causing the clockspring to become inoperative. If removed and handled properly using the correct procedures, it should remain in the "centered" position. If there is any question as to whether the clockspring is in the "centered" position of travel, perform the clockspring centering procedure before installing the steering wheel.

    GC0187196Courtesy of CHRYSLER GROUP, LLC
  5. While holding the steering wheel firmly in place, remove the steering wheel retaining nut (1).
  6. While holding the steering wheel firmly in the STRAIGHT-AHEAD position, remove the steering wheel from the steering column shaft splines.
  7. If necessary, remove the remote radio switches. Refer to SWITCH, REMOTE RADIO, REMOVAL .
  8. If necessary, remove the Electronic Vehicle Information Center (EVIC) switch. Refer to SWITCH, EVIC CONTROL, REMOVAL .
  9. If necessary, remove the speed control switch. Refer to SWITCH, SPEED CONTROL, REMOVAL .
scientia non olet · About LEMON Manuals