LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2021 >> Compass Altitude, FWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery System (Service Information) >> Battery >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

NOTE:

LHD shown, RHD similar.

CAUTION:

The battery terminals must only be disconnected with the ignition key at STOP or extracted, never with the key at RUN or with engine started. The battery terminals must only be disconnected at least 1 minute after turning the ignition key to STOP.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0179037Courtesy of CHRYSLER GROUP, LLC
  2. Press the retaining tabs (1) for the cover to remove it.
    GC0178784Courtesy of CHRYSLER GROUP, LLC
  3. Remove the nut (1) and disconnect the electrical connection from the power supply box.
  4. Loosen the positive terminal nut (2).
    GC0179115Courtesy of CHRYSLER GROUP, LLC
  5. Remove the screws (1) and remove the plate.
    NOTE:

    BUX vehicle shown in illustration, NAFTA similar. The NAFTA market does not  use a second nut (2) on the 150 Amp fuse.

    GC0179407Courtesy of CHRYSLER GROUP, LLC
  6. Remove the nut (1) and move the bracket with retaining belt.
  7. Remove the battery.
scientia non olet · About LEMON Manuals