Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.NOTE:
This DTC is set when the APP Sensor values are learned in-plant but do not reach the minimum or maximum voltage range.
- With the scan tool, erase DTCs.
- Start the engine.
- With the scan tool, read DTCs and record on the repair order.
Is the DTC active or pending?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- Turn the ignition on.
- CHECK FOR OTHER DTCS
- Refer to the recorded DTCs.
Are there any APP Sensor out of range and 5-Volt Supply DTCs active or pending?
Yes
- Perform the applicable diagnostic procedure(s). Refer to PCM DIAGNOSTIC CODE INDEX .
No
- Go To 3
- Refer to the recorded DTCs.
- PERFORM THE ETC RELEARN AND RETEST FOR DTC
- With a scan tool perform the ETC RELEARN function.
- With the scan tool, erase DTCs.
- Start the engine.
- With the scan tool, read DTCs.
Is the DTC active or pending?
Yes
- Replace the APP Sensor in accordance with the Service Information. After installation is complete, perform the ETC RELEARN function.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Test Complete.