Removal And Installation: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Squeeze the release buttons together and gently unsnap the trim cover (1) from the height adjuster on the upper B-pillar to access the front seat belt turning loop mounting nut.
- Remove the mounting nut (1) that secures the seat belt turning loop (2) to the height adjuster.
- Remove the seat belt turning loop (2) from the height adjuster.
- Remove the upper B-pillar trim. Refer to PANEL, B-PILLAR TRIM, LOWER, REMOVAL AND INSTALLATION
or PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION
.
- Remove the two mounting bolts (1) that secure the height adjuster (2) to the inside of the B-pillar.
- Remove the adjuster (2) from the B-pillar.