Sensor, Crankshaft Position: Removal: 3.6L

The Crankshaft Position (CKP) sensor is mounted into the right rear side of the cylinder block.

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

   Courtesy of CHRYSLER GROUP, LLC

3. Disconnect the Crankshaft Position (CKP) Sensor wire harness connector (1).

   Courtesy of CHRYSLER GROUP, LLC

4. Remove the CKP sensor bolt (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Carefully twist the CKP sensor and remove from the cylinder block.

   Courtesy of CHRYSLER GROUP, LLC

6. The CKP sensor O-ring (1) can be reused if not damaged.