Sensor, Crankshaft Position: Removal: 6.2L

Courtesy of CHRYSLER GROUP, LLC

The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine block. It is positioned and bolted into a machined hole in the engine block.

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. Remove the starter. Refer to 6.2L .
4. Disconnect the CKP sensor wire harness connector (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Remove bolt (1) and the CKP sensor from the engine block.